M-D010B Corner Shower enclosure (36x36x84in)

MD-010B is a shower enclosure.

Shower enclosure, size 36x36x82H in

• Corner unit
• Polished finish
• Accessory rack
• Mirror
• Body massage jets
• Rainfall shower
• Hand held shower
• Molded seat
• Sliding door
• Tempered glass

GENERAL INFORMATION

• Units come in panels and are assembled with screws, nuts, and bolts on site
• All joints and seams are to be caulked with 100% silicone at room temperature (no latex caulking)
• It is advised to have base onsite before preparing drain location
• Access panel near jets and manifold is recommended
  Note: All shower bases need to be leveled in its final resting position.  Mark the placement, then pull base out and begin assembly.

TECHNICAL INFORMATION

• Materials: acrylic, tempered glass
• Dimensions: 36 x 36 x 82 IN

PLUMBING REQUIREMENTS

• The unit is equipped with hot and cold metal braided water supply hoses with ½ national pipe threaded fitting
• Hot and cold shutoffs with ½ -male national pipe thread (not included) should be installed
• Supply hoses are to be connected from the faucet manifold on the unit to the shutoff valves
• All water jet features are pre-plumbed with reinforced braided flexible supply hose
• All fixtures and fittings must be checked for tightness as they may have been loosened during transportation
  Note: The flexible drain hose included with this unit is designed for installation into a floor drain only. Substituting the existing drain setup for a setup of the installers’ choice will not void the warranty of the unit as long as there is no evidence of misuse or damage to the base.  If the substitute drain system is used, a ?" stub must be added to the main shower drain line to connect the steam generator’s automatic flushing drainage hose