M-K557 (33) Steam Shower with 5' massage tub (59x33x88in)

MK-557-33 is a personal steam room with a massage bathtub 59" wide.

Personal Steam Room with massage bathtub, size 59 x 28 (33) x 88H in 

• Available in ivory, white, and black
• Tub filler is included
• Polished finish
• Phone hook-up
• FM radio
• Steam aromatherapy outlet
• Accessory rack
• Mirror
• Foot massage
• Underwater lighting
• Body massage jets
• Rainfall shower
• Hand-held shower with height-adjustable bracket
• Molded seat
• Adjustable time settings
• Computer panel with remote
• Sliding door
• Circulation fan
• Fluorescent lighting
• Interior access panel
• Drain access panel
• Tempered glass
• Self-cleaning steam generator
• Left/right models available

GENERAL INFORMATION

• Units come in panels and are assembled with screws, nuts, and bolts on site
• All joints and seams are to be caulked with 100% silicone at room temperature (no latex caulking)
• Access panel near control panel and jets is recommended
• It is advised to have tub onsite before preparing drain location
  Note: Tub needs to be leveled in its final resting position.  Mark the placement, then pull tub out and begin assembly of wall panels. Glass piece on the front of bathtub is fixed and does not open

TECHNICAL INFORMATION

• Materials: acrylic, tempered glass
• Power Supply:
• Steam Box - 220V
• Water Pump - 110V
• Steam Ready: 2-5 MIN
• Dimensions: 59 x 28(33) x 88H in

ELECTRICAL INFORMATION

• Steam box  - 1st  dedicated line for steam box only
  220V / 13.6 amps - 1 dedicated 12-2 wire (line 1, line 2, and ground) 220V, 20 amp GFCI breaker
• Water pump - 2nd dedicated line needed for pump
  110V - .75KW/ 7 amps / 12-2 wire with 110V - 20 amp GFCI breaker
• Inline Heater System requires one 12.5amp, 120V service that is GFCI protected (may plug into existing 110V circuit)

PLUMBING REQUIREMENTS

• The unit is equipped with hot and cold metal braided water supply hoses with ½ national pipe threaded fitting
• Hot and cold shutoffs with ½ -male national pipe thread (not included) should be installed
• Supply hoses are to be connected from the faucet manifold on the unit to the shutoff valves
• All water jet features are pre-plumbed with reinforced braided flexible supply hose
• Note: All fixtures and fittings must be checked for tightness and leaks as they may have loosened during transportation. It is advised to have tub onsite before preparing drain location
• Substituting the existing drain show for a different one will not void the warranty as long as there is no damage or evidence of misuse to the base
  Note: The flexible drain hose that is included with this unit is designed for installation into a floor drain only