M-301 Personal Steam Shower and Sauna Duo (64x47x86in)

M-301 is a steam shower and sauna duo model.

Steam shower and sauna duo, size 64x47x86H in 

• 3kW self-draining steam generator
• 3kW sauna heater
• Cypress wood
• Available white
• Polished finish
• Phone hook-up
• FM radio
• Steam aromatherapy outlet
• Accessory rack
• Mirror
• Foot massage
• Body massage jets
• Rainfall shower
• Hand-held shower with height-adjustable bracket is included
• Molded seat
• Thermostatic valve
• Adjustable time settings
• Computer panel with remote control
• Sliding door
• Circulation fan
• Fluorescent lighting
• Tempered glass
• Left/right models available

GENERAL INFORMATION

• Units come in panels and are assembled with screws, nuts, and bolts on site
• All joints and seams are to be caulked with 100% silicone at room temperature (no latex caulking)
• Access panel near control panel and jets is recommended
• It is advised to have tub onsite before preparing drain location
  Note: Tub needs to be leveled in its final resting position.  Mark the placement, then pull tub out and begin assembly of wall panels. Glass piece on the front of bathtub is fixed and does not open

TECHNICAL INFORMATION

• Materials: acrylic, tempered glass, cypress wood
• Power Supply: 220V/-2 separate circuits
• Steam Ready: 2-5 MIN
• Sauna Ready: 5-10 MIN
• Dimensions: 64 x 47 x 86 IN

ELECTRICAL INFORMATION

• 220V- 20 amp GFCI breakers needed for both heaters
• 2 separate dedicated 12-2 wires - 1 for steam and 1 for sauna (line 1, line 2, and ground)
• There is a length of wire from the control box supplied to connect to power source
  Note: THE SAUNA CONTROL BOX MUST BE INSTALLED OUSTIDE OF THE UNIT.  To connect the sauna system you will need a length of wire from one of the two dedicated power lines to the sauna control box and a length of wire from the sauna control box to the sauna box inside the sauna room section of M-301 dual steam sauna unit. Wire is not included

PLUMBING REQUIREMENTS

• The unit is equipped with hot and cold metal braided water supply hoses with ½ national pipe threaded fitting
• Hot and cold shutoffs with ½ -male national pipe thread (not included) should be installed
• Supply hoses are to be connected from the faucet manifold on the unit to the shutoff valves
• All water jet features are pre-plumbed with reinforced braided flexible supply hose
• Note: All fixtures and fittings must be checked for tightness and leaks as they may have loosened during transportation
• Substituting the existing drain show for a different one will not void the warranty as long as there is no damage or evidence of misuse to the base
  Note: The flexible drain hose that is included with this unit is designed for installation into a floor drain only